Skip to content
EdgeleyLock & Key Co.
Open 24/7(289) 216-1246Open 24/7
Person holding a key beside a brass-colored deadbolt on an open painted door while another person watches from inside. — Home Lockout Service, Edgeley
Technician examining detached commercial lock hardware on a table outside a shop entrance. — Business Lockout Service, Edgeley

Lockouts · Edgeley

Home Lockout Service in Edgeley

The keypad on the smart lock blinks once and goes dark.

Call (289) 216-1246

In plain words

Where your key is decides most of what happens after the door opens. If it is sitting on the counter inside, the job is simply to open the door and hand the house back to you with the lock untouched. If the key has been lost somewhere in town, opening the door solves tonight but leaves a working key in circulation, so the sensible follow-up is to rekey the cylinder to a new key while the locksmith is already there. Either way the service begins with confirming you belong at that address and ends with a door that locks and unlocks normally.

Sound familiar?

Someone pushed the privacy button on the bathroom door and pulled it shut behind them, leaving the room locked and empty. The little emergency slot on the outside is stripped, and the tiny release key that came with the handle disappeared years ago.

How the visit goes

Home Lockout Service

How the visit goes

Hands clamping a key blank in a key-cutting machine on a wooden bench, with a car remote, screwdriver and wire brush nearby. — Edgeley
Technician in a cap fitting a black mortise lock case into the edge of a wooden door beside an old knob plate. — Edgeley
  1. Where the key went

    The next question is about the key rather than the lock. A key left on the hall table means the lock is healthy and only the door needs opening. A key lost on a bus, dropped in a parking lot or taken with a stolen bag means a stranger could be holding it, which changes the advice given after entry. A key that turns without moving anything points to wear inside the cylinder or a broken tailpiece, and a key that snapped calls for extraction before anything else. Ten seconds of honest history about the key saves guesswork and shapes the whole visit.

  2. Getting past a dead smart lock

    A keypad lock that has lost power is usually opened by giving it power back. Many models expose two small terminals under the keypad that accept a fresh nine-volt battery held against them, which wakes the lock long enough to enter a code. If that route is unavailable, the locksmith removes the cover over the mechanical override and picks or decodes that small cylinder like a conventional lock. Where the lock has no keyway at all, that model's own recovery method is used instead. Afterwards, batteries are replaced, the door is confirmed to relock automatically if it should, and any forgotten code is reset from the inside.

  3. A door and frame that line up again

    When the lockout traced back to a door that had sagged or swollen, you get more than an open door: the reason is dealt with. Hinge screws that had worked loose are tightened or replaced with longer ones that bite into the framing, the strike plate is adjusted or its pocket deepened so the bolt has room to throw fully, and any weatherstrip that was pushing the door out of square is trimmed. Afterwards the bolt should slide with a fingertip on the thumb-turn and no shoulder on the door. Check it again at the turn of each season, since wood keeps moving with the humidity, and a two-minute screw check saves a return visit.

Home Lockout Service

In the van

  • Nine-volt battery for smart locks

  • Replacement cylinder or deadbolt

  • Plug follower and repinning kit

  • Pick and tension tools

  • Strike plate and long hinge screws

Technician in a cap and clear glasses holding a yellow impact driver at the latch edge of a black door. — Edgeley

Home Lockout Service

What affects the quote

  1. Restricted or high-security keyways

    Security pins, sidebars and patented keyways take longer to open and, if replaced, cost more as hardware than a standard cylinder. Restricted keys also have to be cut from the system's records rather than duplicated.

  2. Interior door or exterior door

    A bathroom privacy lock or a bedroom door is generally a lighter job than an exterior deadbolt, and an old keyed interior mortise lock sits somewhere between. The quote follows the hardware, not the room.

  3. Drilling and a replacement cylinder

    If the cylinder has to be drilled, the quote gains the new cylinder or complete deadbolt and the labour to fit it. You are told this before the drill comes out, never after.

What to have ready

  • If the key is lost, would you like the locks rekeyed during the same visit?
  • Is the door swollen, sagging or hard to close even when it is unlocked?
  • Is the key inside the house, lost, broken in the lock, or turning without opening?
Call (289) 216-1246

Home Lockout Service: questions

Questions
Can you get me in if my smart lock has died?

Yes, usually. Backup access on a keypad or app-controlled deadbolt depends on the model. Many carry small external terminals that wake the lock when a fresh nine-volt battery is touched to them, long enough to enter your code; some also keep a conventional keyed override behind a cover, which a locksmith can pick or decode like any other cylinder, while other current models have no cylinder at all and rely only on their own recovery method. Once inside, the batteries are replaced and your codes are checked.

Is a double-cylinder deadbolt a good idea after a lockout?

A deadbolt keyed on both sides is sometimes suggested for doors with glass beside them, but on a main escape door it means finding a key to get out. A door people use to leave the home should open from the inside without a key or special knowledge, especially in an emergency. A single-cylinder deadbolt with a thumb-turn, paired with a reinforced strike and a proper glass film if needed, keeps both security and a clear way out.

My key turns but the door stays locked. What is going on?

A key that spins freely without moving the bolt usually means the connection between the cylinder and the bolt has failed: the tailpiece or cam at the back of the cylinder has broken or slipped, or the internal parts of an older mortise lock have worn. The good news is that this is a hardware fault rather than a lost key, so once the door is opened the fix is a repaired or replaced cylinder and your keys keep working.

Related services

Home Lockout Service near you

Call(289) 216-1246

Request a visit

Or call (289) 216-1246 · open 24/7